StereoPi Forum

will the parametres that are in calib_data folder work (i have IMX219-160 camera) ?

another question why there are two folders 240 and 480?what are they used for ?

%Run 5_dm_tune.py
Read and split image...
Read calibration data and rectifying stereo pair...

(5_dm_tune.py:3852): Gtk-ERROR **: 05 ...

i need to use yolov8 in my project and when i try to install ultralytics it depends on pytorch>=1.8 but it's impossible to install pytorch for the 32bits raspi os that you provided .is there any busterOS images for 64bits or if there is any solution to this problem.

thank you for your help,i am gonna test these steps tomorrow, i hope this works.
update:
it finally worked thank you so much.

i am sorry i am kinda new to this can give me further instructions ,is there any way to get the legacy camera stack on .
i am sorry in advance for the trouble ,thank you for your guidance.

i didn't altered the test.py but i changed gpu_mem to 512Mb but the same error .i attached the results for the 2 commands you asked me to do and after that i tried to change the mode to legacy but i didn't find the option in the raspi-config as you can see.do i need to disconnect the ribbon and ...

hello everyone !
i am using the stereoPi v2 with CM4 when i ran the 1_test.py i get the following error
mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)
mmal: mmal_component_create_core: could not create component 'vc.ril.camera' (1)
Traceback (most recent call ...